城市公共厕所设计标准（CJJ 14-2016）

4．3．1 公共厕所的平面设计应符合下列规定：

5 每个大便器应有一个独立的厕位间。

4．3．2 公共厕所的建筑设计应满足下列要求：

7 厕位间的隔板及门应符合下列规定：

1)隔板及门的下沿与地面距离应大于0.10m，最大距离不宜小于0.15m；

2)隔板及门的上沿距地面的高度：一、二类公厕不应小于1.8m、三类公厕不应小于1.5m；独立小便器站位应有高度为0.8m 的隔断板，隔断板距地面高度应为0.6m；

Design Standards for Urban Public Toilets (CJJ14-2016)

4.3.1 The layout design of public toilets should comply with the following regulations:

5. Each toilet should have an independent toilet compartment.

4.3.2 The architectural design of public toilets should comply with the following requirements:

7. The partitions and doors between the toilet seats should comply with the following regulations:

1) The gap between the lower edge of the partition / door and the ground should be greater than 0.10m, and the maximum gap should not be less than 0.15m;

2) The height of the upper edge of the partition and door from the ground: Class I and Class II public toilets should not be less than 1.8m, and Class III public toilets should not be less than 1.5m; The independent urinal station should have a partition board with a height of 0.8m, and the height of the partition board from the ground should be 0.6m;